How to Recover Data from a Damaged SSD Drive? Effortlessly

If you are searching for a solution to recover data from a damaged SSD drive,. So you are at the right place. Here, we will tell you about the most effective solution.

Most laptops and computers today have SSD (solid-state drive) components. These hard drives are faster, consume less power, and offer better performance than traditional hard drives. However, with its increasing popularity, more and more SSD users are experiencing data loss due to various reasons. Don’t worry, even if you lose data due to SSD failure or damage, there is a way to recover it.

However, restoring data from an SSD may seem a little difficult because the design of an SSD is different from that of a regular hard drive. This article describes various methods used to recover files from corrupted SSD.

Common Symptoms of SSD Failure

Presence of Bad Blocks Similar to bad sectors on a typical hard drive, SSDs can contain bad blocks for a variety of reasons. As a result, simple read or write operations take longer. You may receive an error message indicating that your computer requires maintenance. In some cases, active apps may also crash.

• Unable to Access or write a File: If a bad block is found, the system may refuse to read or write certain data. If bad blocks are found before data is written, the file is not corrupted. Otherwise, if a block is found after writing data, you will not be able to access it without restoring the data.
• The File System Needs to be Repaired: These types of messages usually appear on Mac and Windows operating systems for various reasons. Most often, this is due to a lost port connection or a bad block.
• Common Boot Errors: If your computer tends to freeze during startup, your SSD drive may be bad. We strongly recommend that you back up your data before a permanent drive failure occurs.
• The SSD Will Be Read-Only: In rare cases, an SSD may become read-only. New data cannot be written, but existing data can be successfully read. It is also a sign or symptom of poor management.

Also read: How to Recover Deleted PPTX File in Windows 10?

Manual Techniques to Repair a Damaged SSD Drive

Once the data is recovered from the damaged SSD, you will be able to recover data from failed SSD. Follow this simple method to repair your damaged SSD.

Solution 1: Update the SSD Firmware

To update the firmware of a faulty SSD, follow the instructions below.

1. Open Windows Explorer by pressing Win logo + E key. Now go to System Explorer.
2. Open Device Manager.
3. Open the properties of the damaged SSD drive.
4. Go to the Hardware ID and Details section.
5. Click OK
6. Install the SSD Firmware Update Tool.
7. View license
8. Click accept
9. Select an available update and click Update Disk.
10. Click “Yes” to confirm.
11. Click “OK” to complete the process.

Solution 2: Update your Windows Drivers

If the file system installed on the SSD is damaged, it may be a sign that your Windows drivers are out of date. Update using the instructions below.

1. Open your computer’s device manager
2. Go to the hard drive properties and click “Update Driver”.
3. After the update is done, re-start your computer.

Solution 3: Run CHKDSK to Repair your Damaged SSD

1. Press Win+S. Type cmd and press Enter.
2. Then select CMD Command Prompt and run as an administrator.
3. Type Write the following command and click the Enter button: chkdsk /f c: (c is the drive letter of the SSD card.)
4. Wait for the scanning process to complete. Then check if the SSD card is available for data recovery.

Solution 4: Format the SSD

If none of the above methods solve the problem, you can try formatting the SSD to resolve the issue. But all files will be deleted after formatting; you need to make a backup copy of all data.

1. Press Win+S. Find Disk Management and press Enter.
2. Find the SSD card you want to format, right-click, select Format and then perform Quick Format.
3. Click “OK” to format the drive.

Typically, a damaged SSD can be repaired by updating the SSD firmware or Windows drivers. It’s worth noting that by following these two steps to recover data from failed SSD, you should retain all the data stored on the damaged SSD. Although  third-party software can help you recover lost data from your SSD drive, it is recommended to avoid losing data again.

Recover Data from A Damaged SSD Drive With Professional Software

A corrupted SSD can be a hassle for users. Usually, files from a damaged SSD drive cannot be recovered, but with SSD Data Recovery Software , this is not the case. This application is capable of recovering files even from severely damaged SSDs.

Download Now Purchase Now

With the help of the application, you can recover permanently deleted file from SSD drive. This utility is capable of restoring corrupted, normal deleted, permanently deleted, damaged, and formatted files and folders. This application recovers photos, videos, games, personal and professional documents, etc. from an SSD drive. Moreover, This tool contains many features.

Also Read: How to Recover Deleted Excel Files from Computer?

Quick Process to Recover Data from a Damaged SSD Drive

You can try this application. By following below mentioned steps:

1. Download and launch SSD drive recovery software on a Windows computer.

• Now you can choose the scan option to recover files from corrupted SSD. For formatted data, you can choose formatted scan option.

• After that, find and preview restored data from Solid State Drive.

• At the end, users can save the retrieved items on their computers.

Final Word

This article describes how to recover data from a damaged SSD drive using two methods: the first is manually, and the second is using data recovery software such as SSD Recovery Tool. This is an affordable and reliable way to recover data from failed SSD. But if that doesn’t work, you can always visit a data recovery center and get your data back easily.